National Instruments Fieldbus - Manual (Page 39)

Index
FBUS-HSE/H1 LD User Manual I-2 ni.com
LEDs
Ethernet LEDs, B-5
Ethernet STATUS LED flashes and
corresponding errors (table), B-4
figure, B-2
H1 network status LEDs (table), B-5
module STATUS LED (table), B-4
troubleshooting, B-1
mounting on a DIN rail (figure), 2-2
mounting to a panel, 2-3
overview, 1-1
power connection, 2-7
pinout (figure), 2-7
power on, 2-7
resetting, A-1
reset switch (figure), A-2
system requirements, 1-3
typical Ethernet network
setup (figure), 1-2
Fieldbus network
connecting to, 2-6
status LEDs, B-5
H
H1 network
connecting to, 2-6
status LEDs, B-5
hardware
configuration and monitoring, 1-2
connecting to the Fieldbus network, 2-6
connector pinout (figure), 2-6
connectors (figure), 2-4
description, 1-3
Ethernet
cable pinouts (figure), 2-5
cable wiring connections (table), 2-5
connecting to the network, 2-3
typical network setup (figure), 1-2
Ethernet LEDs
figure, B-2
LINK, B-2
POWER, B-2
PROCESS, B-2
RX, B-2
STATUS, B-2
TX, B-2
installation and configuration, 2-1
installing the network panel accessory
(figure), 2-3
LEDs
Ethernet STATUS
flashes and corresponding errors
(table), B-4
H1 network status LEDs (table), B-5
troubleshooting, B-1
module STATUS LED (table), B-4
mounting on a DIN rail (figure), 2-2
mounting to a panel, 2-3
overview, 1-1
power connection, 2-7
pinout (figure), 2-7
power on, 2-7
system requirements, 1-3
help
professional services, D-1
technical support, D-1
high speed Ethernet (HSE), definition of, 1-1
how to use manual set, vii
HSE, 1-1
I
instrument drivers, D-1
K
KnowledgeBase, D-1