NETGEAR KWGR614 - Manual (Page 33)

54Mbps Wireless Router Model KWGR614 Reference Manual
Wireless Configuration 2-15
v1.2, September 2006
4. Click Apply to save your settings.
How to Restrict Wireless Access by MAC Address
To restrict access based on MAC addresses, follow these steps:
1. Log in to the KWGR614 wireless router at URL http://www.routerlogin.net. Enter the default
user name of admin and default password of password, or whatever LAN address and
password you have set up.
2. Click Wireless Settings in the Advanced section of the main menu of the KWGR614 wireless
router.
3. From the Wireless Settings menu, click Setup Access List to display the Wireless Access
menu shown below.
Note: If you use a wireless computer to configure WPA-PSK or WPA2-PSK settings, you
will be disconnected when you click Apply. You must then either configure your
wireless adapter to match the wireless router WPA settings or access the wireless
router from a wired computer to make any further changes.
Note: When configuring the wireless router from a wireless computer whose MAC
address is not in the Trusted PC list, if you select Turn Access Control On,
you will lose your wireless connection when you click on Apply. You must
then access the wireless router from a wired computer or from a wireless
computer which is on the access control list to make any further changes.
Figure 2-7