Napco Security Technologies F-TPG - Manual (Page 15)

15
If a fire is detected, the siren will sound a distinct pulsating tone and the FIRE indicator on the Ga-
rage Touchpad will be flashing. If a Fire Alarm does occur:
* Note: This feature may not apply to your system. Consult your installer to determine if your system includes fire protection.
1
If a fire is in progress, evacuate the premises immediately! Call the Fire Department from an outside phone.
2 If there is no evidence of a fire, press SILENCE OR insert your F-IFOB key into the Garage Touchpad.
The siren will silence, and FIRE on the Garage Touchpad will stop flashing, and light steady.
3 Determine which device went into alarm. If you are protected by smoke detectors, the light on the
active detector will be lit. Once it is determined which smoke detector is in alarm, press
SILENCE to
reset the smoke detector.
4 If the Fire Zone has reset properly, the FIRE light should go out in approximately 30 seconds. If it
does not go out, press SILENCE again in a few minutes. If it still does not go out, call for service.
Fire-Zone Trouble
The system is constantly monitoring the Fire Zone to insure the connections to the protective de-
vices are in good working order.
• If a problem on a Fire Zone is detected, a System Trouble will display. The sounder will activate
and the Trouble TBL light will blink 7 times.
Press the SILENCE button to silence the sounder. Call for service immediately.
F I R E P R O T E C T I O N *
TBL
FIRE
FIRE
F-TPG_OI309.06_USER_anch...
page 15
Friday, October 28, 2005 15:16
Composite