Napco Security Technologies F-TPG - Manual (Page 9)

9
AR M I N G AN D L E AV I N G W I T H O T H E R S S T AY I N G
1 Check the Garage Touchpad indicators. The green READY light should be ON-STEADY,
indicating that the system is ready to arm.
•
If the green READY light is BLINKING, this indicates that a zone is faulted. The READY light is blinking out the zone
number of the open zone. Count the flashes and look at your zone list to see which zone is open and secure it
(close the door or window, etc.). If you cannot immediately secure the zone, it may be bypassed (see page 7).
•
If the green READY light is OFF, the optional second deadbolt is not locked. If there are two deadbolts in the system,
the other deadbolt must be locked before the system can be armed. Go to the other deadbolt location and lock it.
2 Press the STAY button on the Touchpad.
3 Open the garage door and exit. (Note: See page 13 if your garage door motor fails).
4 Close the garage door from the outside to arm the system (either by pressing A1 or A2 on your
Keyfob or with your existing garage door opener remote control).
If the garage door has not been closed within 3 minutes of pressing STAY , the system will
revert back to a disarmed state.
If you are arming and leaving with other family members remaining home:
STAY will begin to flash, indicating the 3 minute exit delay period.
READY
STAY
F-TPG_OI309.06_USER_anch...
page 9
Friday, October 28, 2005 15:16
Composite