System trouble error codes – Napco Security Technologies F-TPG User Manual

Page 17

Advertising
background image

17

Your Freedom Alarm System is constantly monitoring its own components, as well as all critical services, such as AC power and the

telephone line, to insure that it is always ready to provide the protection for which it was designed. When a system trouble occurs, the
Garage Touchpad will caution you with a Trouble TBL light and a beeping sounder.

If you cannot immediately fix the trouble, the system can still be used. Simply press SILENCE to view the trouble as described below

and press SILENCE again to exit the VIEW TROUBLE mode. The system can now be armed.

To view the trouble, press SILENCE, count the number of Trouble TBL and READY flashes and refer to the following table. If there

is more than one trouble to view, press SILENCE again to scroll to the next trouble, and again to exit the VIEW TROUBLE mode. The
Trouble TBL light will remain pulsing as a reminder if the trouble is still present. NOTE: If the Touchpad siren chirps once every 10 sec-
onds, call for service.

SYSTEM TROUBLE ERROR CODES

TBL

Flashes /

Touchpad beeps

READY

Flashes

Trouble Condition

Action

STEADY

NONE Zones Bypassed

This is a reminder that zones have been bypassed (by pressing

BYPASS

). If it is

necessary to bypass any inoperative zones, it is important to have the zones re-
paired as soon as possible.

1

NONE AC Power Failure

This trouble will occur if AC power is not present. Make sure the system trans-
former is plugged into its AC receptacle and check the circuit breaker, otherwise
call for service.

2

NONE Low Battery

If there has been a recent power failure, the battery may be partially depleted and
must be recharged by the control panel. If the trouble does not clear in 24 hours,
call for service.

3

NONE Communication

Failure

The system was not able to report to central station. If this is due to a temporary
interruption in the telephone service, the trouble can be cleared when the service
is restored by pressing

SILENCE

again.

4

NONE Telephone Line Cut

The telephone line has failed. If telephone service has been temporarily inter-
rupted, the trouble will clear when restored. Otherwise, call for service.

5

NONE Bell/Siren Trouble

There is a problem with the Bell or Siren. Call for service.

F-TPG_OI309.06_USER_anch...

page 17

Friday, October 28, 2005 15:16

Composite

Advertising