Napco Security Technologies F-TPG - Manual (Page 8)

8
AR M I N G W H E N S T AY I N G H O M E
Arming in the Stay mode allows you to remain home with the perimeter protection active and the interior protection off, so
that you may move freely about the premises.
1 Check the Garage Touchpad indicators. The green READY light should be ON-STEADY, indicating
that the system is ready to arm.
•
If the green READY light is BLINKING, this indicates that a zone is faulted. The READY light is blinking out the zone
number of the open zone. Count the flashes and look at your zone list to see which zone is open and secure it (close
the door or window, etc.). If you cannot immediately secure the zone, it may be bypassed (see page 7).
•
If the green READY light is OFF, the optional second deadbolt is not locked. If there are two deadbolts in the system, the
other deadbolt must be locked before the system can be armed. Go to the other deadbolt location and lock it.
2 Press the STAY button on the Touchpad.
If the garage door is already closed, the ARMED indicator will light and STAY will begin to flash. The
system will arm in the Stay mode within 3 minutes.
3 If the garage door is NOT closed, close the garage door from the inside to arm the system.
If the garage door has not been closed within 3 minutes of pressing STAY , the system will re-
vert back to a disarmed state. (Note: See page 13 if your garage door motor fails).
The STAY indicator will stop flashing and light steady, indicating the system is armed in the Stay mode.
READY
ARMED
STAY
STAY
F-TPG_OI309.06_USER_anch...
page 8
Friday, October 28, 2005 15:16
Composite