NordicTrack NTB49030 User Manual
Page 13
13
29. Route the Cable Tool (27) through the indicated
Side Top Frame (7).
Make sure that the Cable
Tool is routed around the bolts in the Top
Frame as indicated; if the High Cable (54) rubs
against a bolt, damage may occur.
Locate the High Cable (54). Thread the end of
the Cable without the Clip (42) into the Cable Tool
(27).
Make sure the Cable is inside of the indi-
cated rods on the Swivel Arm (14).
Pull the High Cable (54) through the Side Top
Frame (7) and remove it from the Cable Tool (27).
31. Route the High Cable (54) around a 3 1/2” Pulley
(45) and through the bracket on the Center Top
Frame (2). Attach the Pulley inside the bracket
with an M10 x 48mm Button Bolt (74) and an M10
Nylon Locknut (62).
32. Route the High Cable (54) around a 3 1/2” Pulley
(45) and through the indicated tube on the Center
Top Frame (2).
Make sure the Cable is routed
over the bolts as indicated.
Attach the 3 1/2” Pulley (45) to Center Top Frame
(2) with an M10 x 48mm Button Bolt (74) and an
M10 Nylon Locknut (62).
30. Attach a 4” Pulley (89) inside the Swivel Arm (14)
with an M10 x 54mm Button Bolt (73), two M10
Washers (65), two 7mm Spacers (48), and an
M10 Nylon Locknut (62).
Make sure the High
Cable (54) rests in the groove of the Pulley.
29
7
27
54
42
Rod
Rod
Cable Tool
Path
30
73
65
14
14
65 62
48
48
54
89
31
32
74
2
62
54
45
45
Cable
Path
54
74
2
62