NordicTrack NTB49030 User Manual
Page 14
14
33. Wrap the High Cable (54) over a 3 1/2” Pulley
(45). Attach the Pulley inside the Center Top
Frame (2) with an M10 x 65mm Button Bolt (86),
two M10 Washers (65), two 12mm Spacers (49),
and an M10 Nylon Locknut (62).
35. Route the High Cable (54) up through the indicat-
ed tube on the Center Top Frame (2).
Make sure
the Cable is routed over the bolts in the
Center Top Frame in the manner shown in
step 32.
Attach a 3 1/2” Pulley (45) inside the Center Top
Frame (2), under the High Cable (54), with an
M10 x 65mm Button Bolt (86), two M10 Washers
(65), two 12mm Spacers (49), and an M10 Nylon
Locknut (62).
Make sure the Cable rests in the
groove of the Pulley.
36. Attach a 3 1/2” Pulley (45) to the Center Top
Frame (2) with an M10 x 48mm Button Bolt (74)
and an M10 Nylon Locknut (62).
Make sure the
High Cable (54) rests in the groove of the
Pulley.
Route the High Cable (54) through the bracket on
the Center Top Frame (2).
34. Wrap the High Cable (54) under a 3 1/2” Pulley
(45). Attach the Pulley and a Short Cable Trap
(47) at the top hole in the indicated “U”-bracket
(19) with an M10 x 54mm Button Bolt (73) and an
M10 Nylon Locknut (62).
Make sure the Cable
Trap is oriented to hold the Cable in the
groove of the Pulley.
33
62
65
65
86
49
49
54
45
2
34
35
36
62
47
19
73
45
54
62
65
65
54
49
49
45
2
86
45
54
74
62
2
Bracket