NordicTrack NTB49030 - Manual (Page 15)

15
37. Thread the end of the High Cable (54) into the
Cable Tool (27). Route the Cable Tool and Cable
through the Side Top Frame (7).
Make sure that
the Cable Tool is routed through the bolts in
the Top Frame as indicated; if the High Cable
rubs against a bolt, damage may occur.
Remove the Cable Tool from the Cable.
Hold a 3 1/2” Pulley (45) inside the High Cable
(54) as shown. Attach the Pulley inside the brack-
et on the Center Top Frame (2) with an M10 x
48mm Button Bolt (74) and an M10 Nylon
Locknut (62).
39. Slide a Clip Cover (43) onto the High Cable (54).
Hold an M6 Nylon Locknut (63) inside a Clip (42),
and insert the High Cable (54) into the Clip and
the Locknut. Insert a screwdriver between the
Locknut and the Clip. Rotate the screwdriver, the
Clip, and the Locknut together until two threads of
the Cable show past the Locknut.
Slide the Clip Cover (43) over the Clip (42).
40. Route the Cable Tool (27) through the Left
Stabilizer (92). Make sure that the Cable Tool is
routed around the bolts in the Stabilizer as
indicated; if the Low Cable (55) rubs against a
bolt, damage may occur.
Locate the Low Cable (55). Thread the end of
the Cable without the Clip (42) into the Cable Tool
(27).
Make sure the Cable is inside the indicat-
ed rod on the Swivel Arm (14). Pull the Cable
through the Left Stabilizer (92). Remove the
Cable from the Cable Tool.
Attach a 4” Pulley (89) inside the Swivel Arm (14)
with an M10 x 54mm Button Bolt (73), two M10
Washers (65), two 7mm Spacers (48), and an
M10 Nylon Locknut (62).
Make sure the Low
Cable rests in the groove of the Pulley.
37
38
39
40
54
7
Between
Bolts
45
74
62
27
Rods
62
65 14
65
73
48
48
54
89
63
27
55
92
62 65
65
Rod
73
48
14
48
89
42
42
43
54
38. Make sure the High Cable (54) is routed under
the indicated rods on the Swivel Arm (14).
Attach a 4” Pulley (89) inside the Swivel Arm (14)
with an M10 x 54mm Button Bolt (73), two M10
Washers (65), two 7mm Spacers (48), and an
M10 Nylon Locknut (62).
Make sure the High
Cable (54) rests in the groove of the Pulley.