NordicTrack NTB49030 - Manual (Page 5)

1
5
92
Warning
Decal
72
62
65
65
1
6
77
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight rack, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
The following tools (not included) are required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight rack can be assembled success-
fully by anyone. However, it is important to real-
ize that the versatile weight rack has many parts
and that the assembly process will take time.
Most people find that by setting aside plenty of
time, assembly will go smoothly.
ASSEMBLY
1.
Insert two M10 x 118mm Carriage Bolts (72) up
through the Left Stabilizer (92), which has a warn-
ing decal in the indicated location.
Note: It may
be helpful to place tape over the heads of the
Carriage Bolts to hold them in place.
Attach the Left Stabilizer (92) to the Base (1) with
two M10 x 70mm Button Bolts (77), two M10
Washers (65), and two M10 Nylon Locknuts (62).
Do not tighten the Locknuts yet.
Repeat this step with the Right Stabilizer (6).
Before beginning assembly, make sure you
understand the information in the box
above.