NordicTrack ELITE NTL19007.1 - Manual (Page 9)

9
7. Slide the Right Upright Sleeve (96) up against
the console assembly. Attach the Right Upright
Sleeve with two 3/4" Screws (4).
Attach the Left Upright Sleeve (not shown) to
the Left Upright (73) in the same way.
73
74
4
96
4
7
8. With the help of a second person, raise the
front of the treadmill and insert the crossbar on
the Base (83) into the cutout in the cardboard
stand as shown.
Have the second person
hold the treadmill to prevent it from moving
forward or backward.
Firmly tighten the four Upright Bolts (72).
With the help of a second person, lower the
treadmill off the cardboard stand.
Cardboard
Stand
72
83
72
8
9. Note the location of the 75 ohm terminal and the
audio/video input jack on the treadmill. For the
television to operate, the Audio/Video Wire
Harness (115) must be connected to the
audio/video input jack on the treadmill, a per-
sonal audio/video player must be connected to
the audio/video jack on the console, or a CATV
cable must be connected to the 75 ohm terminal
(see page 10).
9
10. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place; the hex key is used to adjust the walking belt (see page 27).
To protect the floor or car-
pet from damage, place a mat under the treadmill.
75 Ohm
Terminal
Audio/
Video
Input
115