National Instruments PXI Terminal Block NI TB-2708 - Manual (Page 7)

© National Instruments Corporation 7 NI TB-2708 Installation Guide
Cabling Options
This section describes the cabling options for accessing signals on the
TB-2708.
A 14-pin connector on the bottom of the TB-2708 provides access to
digital I/O signals. Use the MFIT-Pigtail Cable Assembly (part number
194123-01) to access digital signals on the TB-2708. The MFIT-Pigtail
Cable Assembly features a 14-pin I/O connector on one end and pigtail
conductors on the other end. The pigtail conductors on the cable assembly
can be used to terminate digital signals to the connector(s) your application
requires. Figure 5 and Table 3 list the pin assignments and wiring
information necessary for connecting the TB-2708 to DIO signals.
Figure 5. 14-Pin Digital I/O Connector
Table 3. TB-2708 Wiring Information for 14-Pos MFIT-Pigtail Cable
Assembly (Part Number 194123-01)
Pin Number Wire Color Signal Name
1 Black GND
2 White P0.0
3 Red P0.1
4 Green P0.2
Pin 14
Pin 8
Pin 7
Pin 1
14
13
12
11
10
9
8
7
6
5
4
3
2
1
PFI 9
CTR 1 OUT
CHASSIS GND
P0.7
P0.6
P0.5
P0.4
GND
CTR 0 OUT
P0.3
P0.2
P0.1
P0.0
GND