NDC comm CompuFax - Manual (Page 17)

3
1.2.4 Server Port Charac t erist ic s
$ MCR NCP
NCP> Connect NODE nodename
Local> SHOW PORT n (n = port number)
Port 8: (Remote)
Character Size: 8 Input Speed: 19200
Flow Control: XON Output Speed: 19200
Parity: None
Access: Remote Local Switch: None
Backwards Switch: None Name: PORT_8
Break: Disabled Session Limit: 4
Forwards Switch: None Type: ANSI
Preferred Service:
Authorized Groups: 0
(Current) Groups: 0
Enabled Characteristics:
Autoconnect, Autoprompt, Input Flow Control, Loss Notification,
Message Codes, Output Flow Control, Verification
1.2.5 Mult iple Syst em s
The CompuFax software is shipped as a saveset on tape. If you plan to load the software on multiple systems,
you may find the installation will proceed faster if the saveset is copied from the distribution media to disk,
moved to the designated systems and then installed from disk. For multiple systems follow the steps listed
here:
Create a temporary target directory in which to load the files:
CompuFax Installation 1—3
$ CREATE/ DIRECTORY target-directory
Move to the target directory you just created:
$ SET DEFAULT target-directory
Mount the tape drive unit for reading:
$ MOUNT tape-drive: NDC
Move the savesets from tape to disk using the command below. Substitute the correct product name;
FAX031.A for a VAX system or FAX_AXP031.A for an Alpha AXP system.
$ COPY tape-drive:product [ ]
1.3 Softw are Installation
1.3.1 Evaluat ion Wit hout Modem
If you are planning only to evaluate the product without the use of a modem device or any fax hardware,
please install the product as indicated in the procedure below and enter 'No' when prompted for the modem.
CompuFax will automatically configure the software accordingly for a null device. Then, proceed to the
section entitled Section 1.4.2.