NDC comm CompuFax - Manual (Page 78)

5 4
Description: This qualifier is used to delete one or more entries from the queue. The entry number is the
number from a SHOW ENTRY report. Up to 32 entry numbers may be specified. OPER or WORLD
privileges are required to dequeue entries for other than the current username.
Note: STOP/ ENTRY and DELETE/ ENTRY are synonyms and are identical in function.
VERIFY
Format:
VERIFY [ON]
VERIFY OFF
Description: This command enables or disables display of command file execution. If verify is disabled,
all command file output is suppressed except error messages. If enabled, command file commands and output
may be viewed. If neither ON nor OFF is specified, the default is ON. When the program is initially started,
verify is disabled.
VIEW
Format:
VIEW file
Description: This command permits the viewing of a fax format (T4) file on a terminal which is capable
of displaying sixel graphics, such as a VT330. Operator privilege is required. The command file
CF_REC_TOOLS.COM has been provided as an example of how this command may be used in processing
received fax files.
/ DOWN SCALE
Format:
/ DOWNSCALE= n
Description: This qualifier is used to reduce the size of the file display. Since the resolution of a terminal
is usually less than that of a fax machine, a fax page will not fit on the screen unless it is scaled down. Valid
scale factors are 1 through 9, where 1 means no reduction in size and 9 is maximum reduction. Note that the
quality of the image is reduced when scaled down. If this qualifier is omitted, the image is not reduced in size.
/ LEFT_MARGIN
Format:
/ LEFT_MARGIN= nnn
Description: Specifies the amount of white space between the left edge of the document and the displayed
image. This is measured in dots or as specified by the / UNIT qualifier. A negative left margin value shifts the
image off the screen on the left, which will allows more of the right hand side of the image to be viewed.
Decimal fractions are allowed.
/ MAX_PAGES
Format:
/ MAX_PAGES= nnn
Description: Specifies the maximum number of pages to be displayed if the document consists of multiple
pages. If this qualifier is not included, there is no limit to the number of pages that will be displayed.
/ MODE
Format:
MODE= nnn
Description: This qualifier is used to customize what is displayed with the VIEW command. If this
qualifier is omitted, the file name, all header information about the file, as well as its contents are displayed. If
you wish to display information selectively, use this qualifier with a value that consists of the sum of the
desired options listed below:
1 Show bitmap image 16 Show Sender ID
2 Show file name 32 Show Receive End Time
4 Show resolution 64 Show Receive Start Time
8 Show # of pages 128 Show current page # (not 1)
256 Show end-of-file message
/ OUTPUT
Format:
/ OUTPUT= file