NDC comm CompuFax - Manual (Page 71)

4 7
Format: / PORTRAIT (D)
Description: Specifies that the current document is to be sent without any rotation sideways.
/ LANDSCAPE and / PORTRAIT apply only to printer format (ASCII) files. This qualifier is ignored for
other file types. This qualifier is positional: if it occurs before the name of the first file to be sent, it applies to
all the files to be sent with this SEND command; otherwise it applies only to the file name that immediately
precedes this qualifier. If the orientation of the document is not otherwise specified it will be sent at the
orientation set by the System Manager for the device it is sent on. The device default orientation is a part of
the SHOW DEVICE/ FULL display. / LANDSCAPE and / PORTRAIT are mutually exclusive. A
# # LANDSCAPE or # # PORTRAIT file directive takes precedence over this qualifier.
/ PRIN T
Format:
/ PRINT
/ NOPRINT (D)
Description: Specifies whether a fax being sent is to be printed also. This is a useful feature to verify the
layout of a fax document that is being sent. Please note, however, that such a printout does not show the
header line, nor does it show a logo, since these are added at transmission time. If the printer has already been
set up to print sent faxes (see SET PRINTER and SHOW PRINTER commands,) the / NOPRINT qualifier
may be used to prevent the document from printing.
/ RESOLUTION
Format:
/ RESOLUTION = FINE
/ RESOLUTION = STANDARD
Description: This command sets the resolution at which the fax is to be sent. This overrides the default
setting for the device, as defined by the System Manager. FINE resolution gives a much better image but
requires roughly twice as long to transmit.
SET
Format:
SET CONVERSION
SET DEVICE
SET JOURNAL
SET ORIENTATION
SET PRINTER
SET CONVERSION
Format: SET CONVERSION ENABLE
SET CONVERSION DISABLE - / WHEN = IMMEDIATE | DEFERRED
/ WSDEFAULT = nnn - / WSQUOTA = nnn - / WSEXTENT = nnn
Description: This command enables or disables all conversions between data types. Additional
information is available under HELP SERVER_OPTIONS CONVERSION. OPER privilege is required to
execute this command.
SET DEVICE
Format:
SET DEVICE [= (n, n, ...)]
Description: Where n, n, ... are device numbers from the SHOW DEVICE display. This command may
be used to modify the settings of one or more devices while the system is up. Changes made with this
command last only until the FAX system is restarted. If it is desired to make the settings permanent, the
server options file must be modified. Use of this command requires OPER privilege. If one or more device
numbers are specified the changes apply only to the specified device(s). Otherwise the changes apply to all
devices. This command allows the following qualifiers. These are fully described in the Help section
Server_Options. Device parameters that are not specified will not be modified.
/ BOR / CLASS
/ CSI / DEVICE_TYPE
/ IN ITIALIZATION _STRIN G / LOGO
/ PREFIX / RECEIVE