NetComm NCT240 - Manual (Page 14)

NetComm NCT240 Installation Guide Release 1.0
Wall mount Mounting
1. Attach the four adhesive feet to the bottom of the first switch.
Figure 4-4. Installing the Switch on a Wall
2. Set the device on a flat surface near an AC power source, making sure there are at least two
inches of space on all sides for proper air flow.
3. If installing a single switch only, go to “Powering On the Switch” at the end of this chapter.
4. If installing multiple switches, attach four adhesive feet to each one. Place each device
squarely on top of the one below, in any order.
14