NetComm NCT240 - Manual (Page 18)

NetComm NCT240 Installation Guide Release 1.0
Console management
1. HyperTerminal setting
2. Bootloader startup
If you not press any key in the below state, system will load the default startup sequence to
do boot our system.
U-Boot 1.1.3 (Jun 29 2006 - 16:38:55) BAS ver:1.00.07
U-Boot code: 00200000 -> 0021CBCC BSS: -> 0022120C
RAM Configuration:
Bank #0: 00000000 128 MB
Flash: 32 MB
In: serial
Out: serial
Err: serial
Net: No ethernet found.
Hit any key to stop autoboot: 3
RTC clock initial start !!!
RTC clock initial end !!!
Scanning JFFS2 FS:
U-Boot 1.1.3 (Jun 29 2006 - 16:38:55) BAS ver:1.00.07
U-Boot code: 00200000 -> 0021CBCC BSS: -> 0022120C
RAM Configuration:
18