NetComm NCT240 - Manual (Page 19)

NetComm NCT240 Installation Guide Release 1.0
Bank #0: 00000000 128 MB
Flash: 32 MB
In: serial
Out: serial
Err: serial
Net: No ethernet found.
Hit any key to stop autoboot: 3
Please choose booting method:
1--Startup from old kernel and old ramdisk
2--Startup from new kernel and old ramdisk
3--Startup from old kernel and new ramdisk
4--Startup from new kernel and new ramdisk
5--Startup from NFS
6--Startup from RAM
7--U-boot command line
Please choose booting method by pressing the option number:
Your choice is: 4--Startup from new kernel and new ramdisk
Do you want to save it as default booting method? y/n
RTC clock initial start !!!
RTC clock initial end !!!
Scanning JFFS2 FS: |
If you press a key during this state, there is a menu for you to do a choice the startup
sequence you prefer. After you choice a startup sequence this time, system will ask you whether
save this choice for next time startup.
Your choice is: 4--Startup from new kernel and new ramdisk
Do you want to save it as default booting method? y/n
RTC clock initial start !!!
RTC clock initial end !!!
Scanning JFFS2 FS: done.
-rw------- 8068015 Thu Jan 05 12:03:55 2006 uImage.ramdisk
-rw------- 1081250 Thu Jan 05 12:03:48 2006 uimage.kernel
drwx------ 0 Thu Jun 08 03:08:47 2006 config
drwxr-xr-x 0 Thu Jan 05 12:26:25 2006 aa
-rw------- 1187 Thu Jan 05 19:28:29 2006 telnet_info1
drwx------ 0 Thu Jan 05 12:01:20 2006 update
### JFFS2 loading 'update/newkernel.image' to 0x3000000
### JFFS2 load complete: 1081262 bytes loaded to 0x3000000
### JFFS2 loading 'update/newramdisk.image' to 0x5000000
In this state, system will take two~three minutes to do system initialize, so please have patience
with this procedure.
BAS>
Before you connect PC to
NCT240 system, you should configure Ethernet first.
BAS>ip
19