NETGEAR ADSL MODEM WIRELESS DG834G User Manual

Page 182

Advertising
background image

Reference Manual for the ADSL Modem Wireless Router DG834G

B-12

NETGEAR VPN Configuration

v1.2, October 2006

5. Configure the DG834G v3 as in the Gateway-to-Gateway procedures using the VPN Wizard

(see

“How to Set Up a Gateway-to-Gateway VPN Configuration” on page 8-21

), being certain

to use appropriate network addresses for the environment.

The LAN Addresses used in this example are as follows:

a. In Step 1, enter toFVL328 for the Connection Name.

b. In Step 2, enter fvl328.dyndns.org for the remote WAN's IP address.

c.

In Step 3, enter the following:

IP Address = 172.23.9.1

Subnet Mask = 255.255.255.0

6. Configure the FVL328 as in the Gateway-to-Gateway procedures for the VPN Wizard (see

“How to Set Up a Gateway-to-Gateway VPN Configuration” on page 8-21

), being certain to

use appropriate network addresses for the environment.

a. In Step 1, enter toDG834 for the Connection Name.

b. In Step 2, enter dg834g.dyndns.org for the remote WAN's IP address.

c.

In Step 3, enter the following:

IP Address = 10.5.6.1

Subnet Mask = 255.255.255.0

7. Test the VPN tunnel by pinging the remote network from a PC attached to the DG834G v3.

a. Open the command prompt (Start -> Run -> cmd)

b. ping 172.23.9.1

Device

LAN IP Address

LAN Subnet Mask

DG834G v3

10.5.6.1

255.255.255.0

FVL328

172.23.6.1

255.255.255.0

Advertising