NETGEAR ADSL MODEM WIRELESS DG834G - Manual (Page 184)

Reference Manual for the ADSL Modem Wireless Router DG834G
B-14 NETGEAR VPN Configuration
v1.2, October 2006
Configuration Summary (Telecommuter Example)
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Assure that there are no firewall restrictions.
Setting Up the Client-to-Gateway VPN Configuration
(Telecommuter Example)
Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN Client and a
network gateway involves the following two steps:
• Step 1: Configuring the Client-to-Gateway VPN Tunnel on the VPN Router at the Employer’s
Main Office
.
Table B-3. Configuration summary (telecommuter example)
VPN Consortium Scenario: Scenario 1
Type of VPN: PC/client-to-gateway, with client behind NAT router
Security Scheme: IKE with Preshared Secret/Key (not Certificate-based)
IP Addressing:
Gateway Fully Qualified Domain Name (FQDN)
Client Dynamic
Figure B-12
Gateway A
ntgr.dyndns.org
192.168.0.1/24
192.168.0.1
WAN IP WAN IP LAN IP
Client B
FQDN 0.0.0.0
Router
(at employer's
main office)
Telecommuter Example
NAT Router B
Router
(at telecommuter's
home office) PC
(running NETGEAR
ProSafe VPN Client)
192.168.2.3
"fromDG834G.com" "toDG834G.com"