Assembly and initial set-up – North Star M157594I User Manual
Page 15
Assembly and Initial Set-Up
15
Step 3. Initial Pump & Engine Preparation
Prepare
Water Pump
Verify pump oil level.
Note: The pump is shipped with oil. *Change oil after first 40 hours, then every 3
months or 500 hours
1. Verify oil level:
a. Remove shipping tape
from oil fill cap.
Verify that oil level is
half way up the sight
glass (or at the
indicator line on the
dip stick, if equipped).
2. If oil level is low, fill
using SAE30 non-
detergent oil or Cat Pump
Oil Item #22158.
3. Replace oil fill cap.
Prepare
Engine
Fill the engine with oil.
Note: The engine is shipped without oil.
Refer to the Engine Manual to locate oil-fill port and for instructions on filling.
Use the oil grade and quantity specified in the Engine Manual.
Figure 5
Oil fill cap
Oil drain valve
Sight glass