Summary of important safety information, Safety – operation – North Star M157594I User Manual

Page 58

Advertising
background image

Summary of Important Safety Information

58

o Allow for wider turns and for more distance to stop.
o Avoid any sudden steering maneuvers, starts, or stops that could create sway.

Rough or sloped terrain. Slow down and exercise extra caution on rough or sloped terrain in order to reduce risk of
rollover. Pick the most level route possible when transporting across fields. Drive up and down slopes that cannot be
avoided, rather than across. Use a vehicle equipped with a Roll Over Protection System (ROPS) if you will be
operating on non-level terrain.

Added length. Be aware of the added length of the pressure washer.

Reduced visibility. Be aware that visibility may be reduced with pressure washer attached. Be extra cautious when
backing up or turning.

Ride / transport. Never ride or transport cargo on the pressure washer.

On public roads. If towing on a public road, make sure to comply with all local, state, and federal towing
requirements. It is the sole responsibility of the purchaser to obtain licensing, trailer lights, safety chains or signage as
needed to comply.

Under the influence. Never tow or operate this pressure washer while under the influence of alcohol, drugs, or
medication.

Safety – Operation

Pre-start

Review safety rules. Before each use of this pressure washer, review the "Rules for Safe Operation." Failure to follow

these rules may result in serious injury or death.

Know how to stop. Be thoroughly familiar with proper use of the equipment and all controls and connections. Know

how to stop the pressure washer and relieve system pressure quickly if needed.

Danger: High-pressure fluid injection hazard. High-pressure fluid spray or discharge from leaks (even pin-sized) or

ruptured components can pierce the skin and inject fluid into the body. Injection injury can result in blood poisoning
and/or severe tissue damage leading to infection, gangrene and possibly amputation.

Check/maintain machine before each use. Check hoses & fittings for damage and leaks before use. Ensure all

components are properly connected. Follow all maintenance instructions specified in pressure washer and engine
manuals.

-

Never operate machine with damaged or missing hoses/parts. Never attempt to repair a high-pressure hose or
component. Always replace it with a part that is rated at or above the pressure rating of this machine.

-

Never run the machine without sufficient lubrication or sufficient water to cool the pump.

-

Never operate unless all safety guards are in place.

Position safely. Place sprayer on firm, level ground to prevent accidental falls and equipment tip-over.

Not in presence of combustibles. Do not use the pressure washer in the presence of flammable vapors, dust, gases, or

other potentially combustible materials. Operate only where open flame or torch is permitted

Use backflow preventer. The use of a back flow preventer (Part #222815 call 1-800-270-0810 to order) on the water

supply hose is recommended and may be required by local code.

Clear work area. Clear work area of all bystanders. Keep children and pets away.

Wear protective gear. High-pressure spray can cause eye/skin injury, hot water can burn, and flying objects/debris can

cause injury. Serious injection injury can result if high-pressure spray penetrates the skin. Operators should wear
waterproof, thermally insulated gloves, safety glasses with side and top protection, face protection, and protective
clothing when operating the machine. If spraying pressure washer specific cleaning chemicals, wear a respirator or mask
to avoid inhalation of vapors if directed on the chemical label.

Wear non-slip footwear. Use of pressure washer can create puddles and slippery surfaces. Wear footwear capable of

maintaining a good grip on wet surfaces.

Check sprayer nozzle. Sprayer nozzle can become a projectile and cause serious personal injury or property damage if

not properly connected to the spray gun. Check to ensure the nozzle has been properly attached to the spray gun before
using the pressure washer.

During use

Safety latch locked before starting engine. Always engage the safety latch on the spray gun trigger before starting the

engine.

Incoming water supply on. Do not run the pump without the water supply connected and turned on. Operating the

pressure washer without an incoming flow of water will damage the pump.

Wait before re-lighting burner. NEVER attempt to immediately run or re-light the burner if it doesn't ignite the first

time. Unburned oil or gas may have accumulated, causing potential explosion or fire hazard.

Advertising