Numark Industries HDCD1 - Manual (Page 5)

Numark HDCD1 - 5 – User’s Guide
INFO - Displays the all information about the track being selected as long as the unit is not in play mode.
If the unit is in play mode you will need to press the back button before pressing INFO. Once on the info
screen you can hold the INFO button for two seconds to enter edit mode where changes can be made to
the track information. Press SAVE to save the edited track information.
TIME - Switches the time mode on the display between elapsed time, remaining time on the track, and
remaining time on the album, CD, or playlist.
MODE - Toggle between the following different play modes
• Continuous plays the CD or playlist once.
• Single plays a song once.
• Repeat repeats an entire CD or Playlist.
• Single Repeat repeats a single track.
PROGRAM – Use the PROGRAM button to create a playlist. Press PROGRAM when a track is selected to
add it to the playlist. Press and hold for 2 seconds to clear the playlist and start again. When all desired
tracks are added press SAVE to review the playlist. Press SAVE again and you will be prompted to name
your list. Press SAVE again to save your playlist.
RECORD - To record audio or music from CD or from the input jacks on the rear of the unit.
o
To Record An Entire CD: Insert a CD and press BACK until you are at the main menu. Choose
“Audio CD”, press RECORD. Choose “Rapid Archive” and press SELECT.
o
To Record A Single Track: Insert a CD and press BACK until you are at the main menu. Choose
“Audio CD” and press select. Then use the wheel to choose a song and press record.
Note: When recording audio CDs you will need to compress them later using the compression feature of
the utility menu.
SAVE - Used to save edited track information, playlists, and to execute delete commands.
RELAY - When this button is active the unit will alternate from one deck to the other and back as each
play sequence ends.
UTILITY – Pressing the utility button will take you to the utility menu where you can:
o
Change audio encoding bit rate settings or compress recorded audio files
o
Delete songs, artists, albums, or playlists
o
Format the hard drive
o
Enable or disable Auto Door Close
o
Enable or disable the Gracenote® Music Recognition Service database lookup (to automatically
identify the artist, song titles and genre of CDs)
o
View the hard drive capacity
o
Check the currently installed firmware version numbers, including the Gracenote database revision
number.
o
Update your Gracenote database.
o
Set or change your system password
POWER - Used to turn the unit on and off.
DRAWER – Used to play audio CDs and MP3 CDR discs.