Nordic Star Products 4.3A - Manual (Page 17)

Sending a fax
XFAX - User’s Guide 4.3a 17
LOCAL_ZONE
Gives the zone that should be used when the area code is not included in
the telephone number, i.e. with local calls. E.g.:
LOCAL_ZONE=LOCALLY
AREA_CODES<...>
Here one area code is given per line and to which zone the area code
belongs. E.g.
AREA_CODES<
08LOCAL
031AREA 3
009ABROAD
0091USA
>
The codes above (AREA 3 etc.) are arbitrary and can be changed, see also
below under ZONES.
It is worth noting that the system goes through all area codes each time and if
several lines match the area code in question, the last found always applies. The
above means that it is possible to use ABROAD as a standard cost for foreign
calls (which of course begin with 009) while for certain countries to which you
often ring the cost can be specified exactly, as for USA in the example above. If
the line with 009 ABROAD had not been there with the above, a number which
began with e.g. 00949 (Germany) would not have been able to be matched
against any line in the table and consequently would have been considered as a
local call.
ZONES time 1 [time 2 [...]] <...>
Here the tariff zones that are to be found are given plus the cost per minute or the
interval between marks at different times of the day. E.g.:
ZONES 0 8 18<
LOCAL 0.29 0.58 0.29
REGION 0.36 0.71 0.36
>
The above means that with e.g. local calls made between 0.00 and 8.00 the price
is 29 öre per minute. Note that the names above, LOCAL and AREA 3, are arbi-
trary and can be chosen according to opinion and taste. However, the same name
must of course be used in the AREA_CODES section so that the right area code
can be paired with the right cost.