Nordic Star Products 4.3A - Manual (Page 43)

Keyword reference
XFAX - User’s Guide 4.3a 43
15. Keyword reference
The keywords below are used in the configuration file ETCDIR/config. The file
can be modified according to requirements with the help of a normal text editor.
If changes are made in the file the faxmaster must be stopped and started again
for the changes to take effect.
When using several lines the keyword can be specific for a certain line (local
keyword) given by means of the following syntax:
LINE tty <
keyword
etc.
>
For example:
LINE tty1a <
INIT_STRING = “AT&H3”
DIAL_PREFIX = “0W”
SEND_ONLY
>
This means that several different types of modem can be used and that certain
lines can be used only for sending and others only for receiving etc.
Note that keywords which apply generally for all lines, global keywords, must be
placed in front of the keywords which are specific to the line in order to achieve
the intended effect. If the same keywords occur several times, the last definition
given always applies.
15.1 General keywords
15.1.1 FAXLINE
FAXLINE = tty1 or
FAXLINES = tty1[:tty2...]
Gives the port or ports the fax system should use. /dev should not be given
before the name of the port. Note that the number of ports which the system
takes note of is limited by the scope of the licence agreement.
15.1.2 ACCESS_HTTP
ACCESS_HTTP=”string”
Specifies which hosts or network can access the HTTP server.
Example:
ACCESS_HTTP=10.1.11.10/32,10.5.1.0/24
See also: USER_FILE