Control panel overlay installation - continued, Finishing the control panel – Nighthawk SILVER STRIKE BOWLING User Manual
Page 15
Silver Strike Bowling™
Version 08/04
Page 13
© Copyright 2004 Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law.
All other marks are the properties of their respective owners. All rights reserved.
Control Panel Overlay Installation - Continued
5. While holding down the overlay over the attached area, very carefully turn over one side and remove the
exposed backing. Gently lay down the exposed overlay from the center outward, smoothing with your
hands or a roller as you go. Be sure the overlay remains straight and square. Repeat the process
with the other side of the overlay, so the entire surface is affixed to the control panel. Make sure all
bubbles have been pressed out for a clean, flat surface.
TIP: Liquid window cleaner can be sprayed onto the control panel before placing the overlay onto
the control panel. The window cleaner will allow the overlay to be positioned with less risk of
damage to the overlay or adhesive. Once in position, use a decal roller or squeegee to force any
excess cleaner out. Be sure to add additional time for the adhesive to cure.
6. Using an X-acto knife (or other sharp instrument) carefully cut around the edges of your control panel,
trimming any excess material.
7. Find the center of each hole you've drilled out for the buttons and use the knife to poke a hole into the
overlay. Make a vertical and horizontal line (like a plus sign) from the center of the hole to the edges. You
should be able to place your button in later with no edges showing.
CAUTION: If you choose to install a Plexiglas® cover over your control panel (not recommended), to ensure the
safety of your players and the quality of your game make sure that all surfaces, edges and bolts that a player may
come in contact with are smooth, safe and secure.
Finishing The Control Panel
1. Reattach the control panel to your cabinet adjusting any hinges or chains where necessary. Make sure
not to pinch or crimp any wires while re-attaching the control panel.
2. Install the trackball to the trackball plate. The trackball must be oriented correctly in order to function
properly. Refer to the diagram located on page 51 for correct orientation. You will need the following parts
in order to install the trackball correctly to the plate: 4 -10/32 x 2½" Phillips Head Machine Screws, 4 - #10
Flat Washers and 4 - #10 Split Lock Washers NOTE: Do not over-tighten the trackball. It will warp and
cause the trackball to not operate correctly.
IMPORTANT! Be sure to install your trackball securely, and maintain it regularly. Loose, worn, or
incorrectly mounted trackballs can result in decreased earnings and possible injury to players.
3. Secure the trackball ground wire to the trackball plate at the 8-32 stud on one end with an 8-32 KEPS nut
and the other end to the cabinet ground stud (usually located near the AC power cord inlet) using an 8-32
KEPS nut.
4. Install the buttons in the holes located on your control panel. Make sure you use the red button assembly
where the hole and decal for the Start button is placed.
5. Attach the micro switches to your newly installed buttons and connect the wires up to the correct pins on
the JAMMA harness.
q
NOTE: The post on the switch labeled COM should connect to the ground wire and the post labeled
NO should connect to the signal wire. See the JAMMA pin out chart on page 43.