Finishing the kit, Side decals and marquee – Nighthawk SILVER STRIKE BOWLING User Manual

Page 16

Advertising
background image

Silver Strike Bowling™

Version 08/04

Page 14

© Copyright 2004 Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law.

All other marks are the properties of their respective owners. All rights reserved.

Finishing The Kit

Side Decals and Marquee

Included with your Silver Strike Bowling kit is a set of decals to place on the side of your cabinet and a brand new
marquee. This will help identify your new game as Silver Strike Bowling. By placing and installing these correctly it
can help give players instant recognition, even from a distance.

Side Decal Installation


The following are the instructions on placing your side decals correctly on to the cabinet:

1. Locate the place where the side decals will be viewed best on your

cabinet. Refer to the diagram included on the decal sheet and to the
right of these instructions for optimal placement.

NOTE: Make sure to have the sides of the cabinet as smooth and
flat as possible, removing all previous residue from prior decals, to
allow for a higher quality finish.

TIP: Liquid window cleaner can be sprayed onto the sides of the
cabinet before placing the decals. The window cleaner will allow
the decal to be removed and re-installed without damaging the
decal or adhesive. The decal roller or squeegee forces the cleaner
out, leaving just the adhesive.

2. Remove the first of the new cabinet side decals from the backing.

3. Center the first decal on the location selected for your cabinet.

4. Using your hands (or a decal roller/squeegee), press down firmly

starting from the center and smooth the side decal outward. Make sure
all bubbles have been pressed out for a clean, flat surface.

5. Repeat for each of the remaining side decals.


Marquee Installation


The following are the instructions for placing the new marquee in your cabinet:

1. Using the old marquee glass as a template, center the glass on top of your new marquee. Make sure that

all the printed images are visible.

2. Using an X-acto® knife or other sharp blade, score the new marquee deeply by following the edges of the

old glass as a guide.

CAUTION: Do not cut on table or counter top. Use a cutting board or a disposable surface.

3. Carefully break off any excess material you have cut off.

4. Be sure the light behind the marquee works.

5. Clean the glass on both sides to give players a clear view of the new marquee.

6. Install the marquee graphics and glass securely.

Advertising