Dedicated cabinets, Dedicated contents, The cabinet – Nighthawk SILVER STRIKE BOWLING User Manual
Page 20: Volume and test switches, Monitor, Security bar, Ticket dispenser
Silver Strike Bowling™
Version 08/04
Page 18
© Copyright 2004 Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law.
All other marks are the properties of their respective owners. All rights reserved.
Dedicated Cabinets
Dedicated Contents
(1) Silver Strike Bowling Dedicated Cabinet
(1) Silver Strike Bowling Manual
(1) Monitor Manual
(1) 4 Leg Levelers
(1) Security Bar
If any parts to your dedicated cabinet are missing/damaged
please contact IT's Technical Support at 847-870-7027 x121.
The Cabinet
NOTE: Diagrams for the Nighthawk Chassis and the dedicated
I/O Board can be found on page 44.
Volume and Test Switches
Your cabinet comes equipped with a bank of buttons mounted
inside the coin door. The Test button will enter you into the
Operator Mode Menus where audits, adjustables, and system
tests can be accessed. Refer to the Operator Menus section
(page 21) of this manual for more information.
There are also two volume control buttons mounted inside the
coin door. Press the button on the left to decrease volume, and
press the button on the right to increase volume. You can also
adjust volume in the Operator Menus (see page 25).
Monitor
Your Silver Strike Bowling cabinet comes equipped with a digital monitor set to SVGA. Silver Strike Bowling
dedicated cabinets support high-res. monitors, offering superb graphics and brilliant colors.
Silver Strike Bowling supports low-res, mid-res., VGA and SVGA monitors. Make sure the I/O Board and monitor
are set properly for best game play results.
Security Bar
Silver Strike Bowling comes with a heavy -duty security bar, to
help you protect your cash box. Use a strong padlock (not
included) to lock the security bar in place. The security bar should
be found installed on the front of your cabinet.
Ticket Dispenser
Silver Strike Bowling supports Entropy 2000 Ticket Dispenser Continuous Type (TD963CR) and Deltronic Labs
DL-1275 Continuous Type ticket dispensers. If you wish to connect a ticket dispenser to this game, you will have
to make a cable with the proper connectors. These ticket dispensers mates with a Molex connector #03-09-1041
or #03-09-1042. The I/O board ticket connector J201 mates with a Molex connector #22-01-2047 or #22-01-
3047. Simply connect pins 1 through 4 on one end directly to pins 1 through 4 on the other end. Consult with your
ticket dispenser's manual to verify installation procedures. (See the Ticket Dispener section in the Operator
Menus starting on page 36.)