Dip switch settings, Coin doors, test switch, and volume control panel, Initial power-up – Nighthawk SILVER STRIKE BOWLING User Manual
Page 17
Silver Strike Bowling™
Version 08/04
Page 15
© Copyright 2004 Incredible Technologies, Inc. All Rights Reserved. Unauthorized duplication is a violation of applicable law.
All other marks are the properties of their respective owners. All rights reserved.
Dip Switch Settings
SW202 Dip Switch Settings 0 = OFF 1 = ON
Positions
4 3 2 1
Function
0 0 0 0
Default
1 0 0 0
Enter Operator Mode Menus
Coin Doors, Test Switch, and Volume Control Panel
Wire the coin doors as per the JAMMA Harness Connection table on page 43. Connect the door lamps to the
appropriate (+12Vdc or +5Vdc) supply. Some games have separate power supply outputs for the lamps. Install a
test switch somewhere convenient inside the coin door area. This switch allows you to enter adjustables, run
diagnostics, and see or clear audits. Make it readily accessible through the coin door. Wire it to the Test wire on
the JAMMA Harness. Silver Strike Bowling has the ability to adjust volume at any time during a game. Install two
push button switches (not included) inside the coin door for easy access. Connect the switches to the JAMMA
harness. Refer to the JAMMA Harness Connection table on page 43.
Initial Power-Up
There are several steps you should take when powering up your Silver Strike Bowling for the first time. This is a
quick checklist for you to follow when doing your first initial power-up:
q
Plug in the game and turn it ON; be sure the game powers up correctly into the attract mode.
q
Adjust volume levels to desired settings.
q
Adjust monitor settings for best picture.
NOTE:
Sound and Video Tests are available through the System Tests Menu. They are beneficial when
making any adjustments. (See System Tests Menu on page 26). Proper monitor and sound adjustment
is very important.
q
Try all money slots. Drop quarters or tokens through to check the coin mechs and insert a bill into the
bill acceptor. Make sure the game is adding credits.
NOTE: Silver Strike Bowling supports most bill acceptors. Installing a bill acceptor is highly
recommended and will increase your earnings. Refer to your bill acceptor's manual for installation
specifications. The bill acceptor can be wired to coin door 3 on the JAMMA.
q
Test all of the player input controls. You can use the PLAYER CONTROL TESTS in the SYSTEM
TESTS MENU.
q
Upon initial power-up the game is set to factory default settings. These settings affect game elements
such as number of credits per coin, difficulty settings, etc. The OPERATOR MENUS section (see page
21) will describe how to alter these settings for your location.
Congratulations!
You have finished installing Silver Strike Bowling!
SW200 Dip Switch Settings 0 = OFF 1 = ON
Position
4 3 2 1
Function
1 1 1 1
Default - Switch Is Not Used
SW201 Video Dipswitch Settings 0 = OFF 1 = ON
Position
4 3 2 1
Video
Mode
Resolution Scan Rate
Monitor
Video connection
0 0 0 1
1
640 X 480
31.5 KHz
VGA
Direct from Chassis, See Diagram on Page 45
0 0 1 0
2
800 X 600
37.8 KHz
SVGA
Direct from Chassis, See Diagram on Page 45
0 1 0 0
4
340 X 255 15.75 KHz
Low Resolution
Through I/O board, See Diagram on Page 45
0 1 0 1
5
512 X 384
25 KHz
Medium Resolution
Through I/O board, See Diagram on Page 45