Nortel Networks MOG6xx - Manual (Page 111)

111
Appendix C: Testing the WLAN Handsets 2210/2211
— dB is the signal strength of the AP
— Ch is the channel of the AP
— 1b2b5b11b is an example of the data rate that may be displayed
Walk around the site to determine supported data rates, one AP at a time. In any location,
use the right arrow key to display the second best AP. Use the right arrow key again to
display the third best, and then the fourth best. The left arrow key returns the display back
to the first best AP.
Each data rate (1, 2, 5.5, or 11Mbit/s) supported by the AP is shown. The rates that are in
the Basic Rate set (sometimes referred to as “required” rates) are indicated by a ‘b’
following the rate number. The Supported and Basic data rates should be the same on all
APs and as is appropriate for the site.
3 When testing is complete, press Power Off/End Call to power off the wireless handset.
Note: The wireless handset remains in Site Survey mode until it is powered off.
Note: Numbers racing across the wireless handset display indicate AP information is
being obtained. A Waiting message indicates the system is not configured properly and
the wireless handset cannot find any APs.