Nortel Networks MOG6xx - Manual (Page 66)

66
WLAN Handsets 2210/2211 configuration
Restore Defaults
The Restore Defaults option resets all user and administrative parameters to their factory defaults.
During configuration, press the right arrow to skip this mode.
Site Survey mode
Site Survey Mode is used to check the signal strength from APs. Site Survey Mode must be set to
10 to make a connection. When Site Survey Mode is selected, the wireless handset remains in this
mode until it is powered off. During configuration, press the right arrow to skip this mode. See
“Site survey” on page 113 for more information on using this mode.
Regulatory Domain
The Regulatory Domain defaults to North America on the wireless handset display. FCC
requirements dictate that the menu for changing the domain be available by password, which in
this case is the LINE button. To change the domain, press LINE and then enter the digits that
represent the domain of the site. Both digits must be entered.
The following are domain digits:
•
01 – North America
• 02 – Europe (except Spain and France) and Japan
• 04 – Spain
• 05 – France
Security
The following are the security options:
•
None – disables any 802.11 encryption or security authentication mechanisms.
• WEP – a wireless encryption protocol that encrypts data frames on the wireless medium,
providing greater security in the wireless network. If WEP Encryption is required at this site,
each wireless handset must be configured to correspond with the encryption protocol set up in
the APs. Select the entries from the following options to enable the wireless handset to acquire
the system.
Note: As of this writing, Spain and France are adopting the general European Regulatory
rules. Check with the wireless LAN administrator or supplier for the correct domain to
enter in these countries.
Note: By default, WEP options are off. If WEP is desired, options must be set in the
wireless handset that match those set in the APs.