Nortel Networks MOG6xx - Manual (Page 86)

86
Appendix B: WLAN Application Gateway 2246
Configuration
This section explains how to configure the WLAN Application Gateway 2246.
For an overview of the WLAN Application Gateway 2246, refer to “WLAN Application Gateway
2246” on page 79 .
For information on installing the WLAN IP Telephony Manager 2245, refer to “Installation” on
page 80 .
Connecting to the WLAN Application Gateway 2246
The initial connection to the WLAN Application Gateway 2246 must be made through a serial
connection to establish the IP address of the WLAN Application Gateway 2246 and the network
parameters.
Further configuration and administration can be performed at a later time through a Telnet
connection.
The Telnet method of connection is also used for routine maintenance of the WLAN Application
Gateway 2246.
Tasks:
• Connect to the WLAN IP Telephony Manager 2245 ( “Connecting to the WLAN Application
Gateway 2246” on page 86 )
• Configure the WLAN IP Telephony Manager 2245 ( “Configuring the WLAN Application
Gateway 2246” on page 88 )
• Change the password ( “Connecting to the WLAN Application Gateway 2246” on page 86 )
• Save the configuration ( “Connecting to the WLAN Application Gateway 2246” on page 86 )
• Check system status ( “Connecting to the WLAN Application Gateway 2246” on page 86 )
Tips: Nortel Networks recommends that you complete the initial network configuration
through the serial connection.
You should also change the default password immediately for security reasons (see
“Connecting to the WLAN Application Gateway 2246” on page 86 ).