NordicTrack NTB58030 - Manual (Page 5)

1.
Attach the left side of the Bottom Crossbar (2) to
the Base (1) without the warning decal, with two
M10 x 94mm Bolts (34), a Large Joint Plate (14),
and two M10 Nylon Locknuts (32). Make sure
the Joint Plate is oriented as shown. Do not
tighten the Locknuts yet.
Note: The Base with the warning decal applied
to it should be attached on the right side of
the weight rack (see WARNING DECAL
PLACEMENT on page 2).
Attach the Bottom Crossbar (2) to the other
Base (not shown) in the same manner.
2. Press a 60mm Square Inner Cap (22) into the
back of the Lat Tower Base (3).
Attach the Lat Tower Base (3) to the Bottom
Crossbar (2) with two M10 x 68mm Bolts (38) and
two M10 Nylon Locknuts (32). Do not tighten the
Locknuts yet.
5
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two people.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight rack, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
The following tools (not included) are required
for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
• Lubricant, such as grease or petroleum jelly,
and soapy water.
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Things Easier for Yourself
Everything in this manual is designed to ensure
that the weight rack can be assembled success-
fully by anyone. However, it is important to real-
ize that the versatile weight rack has many parts
and that the assembly process will take time.
Most people find that by setting aside plenty of
time, assembly will go smoothly.
ASSEMBLY
Before beginning assembly, make sure you
understand the information in the box
above.
1
2
34
These holes
are closer
to this side
of the Plate.
34
2
1
14
32
32
3
2
22
38
32