NordicTrack NTB58030 - Manual (Page 9)

9
11. Wrap the Cable (31) around an 89mm Pulley
(26). Attach the Pulley and a Cable Trap (27) to
the Weight Carriage (10) with an M10 x 45mm
Bolt (36) and an M10 Nylon Locknut (32). Make
sure the Cable Trap is outside of the bracket
and oriented to hold the Cable in the groove
of the Pulley.
12. Wrap the Cable (31) around an 89mm Pulley
(26). Attach the Pulley and a Cable Trap (27) to
the bracket on the Lat Tower (8) with the M10 x
75mm Bolt (40) used in step 10 and an M10
Nylon Locknut (32). Make sure the Cable Trap
is oriented to hold the Cable in the groove of
the Pulley.
12
11
31
26
32
27
40
31
10
36
27
32
26
8
13. Route the Cable (31) through the Lat Tower Base
(3) and around an 89mm Pulley (26). Attach the
Pulley to the bracket on the Lat Tower Base with
an M10 x 45mm Bolt (36) and an M10 Nylon
Locknut (32).
14. Route the Cable (31) under an 89mm Pulley (26)
and through the Foot Plate (13) as shown. Attach
the Pulley to the Foot Plate with an M10 x 45mm
Bolt (36) and an M10 Nylon Locknut (32).
Attach the Foot Plate (13) to the Lat Tower Base
(3) with two M10 x 19mm Bolts (37) and two M10
Nylon Locknuts (32). Do not tighten the
Locknuts yet.
Attach the Foot Plate (13) to the Bottom Crossbar
(2) with two M10 x 94mm Bolts (34), two M10
Washers (33), and two M10 Nylon Locknuts (32).
Tighten all of the M10 Nylon Locknuts (32)
used in steps 1–14.
13
14
32
31
3
32
33
32
32
32
32
3
34
13
31
37
26
2
33
26
36
36