NordicTrack NTB58030 User Manual
Page 8
8
7.
Attach the Left Rear Upright (4) to the left Front
Upright (6) with four M10 x 94mm Bolts (34), two
Small Joint Plates (15), and four M10 Nylon
Locknuts (32). Do not tighten the Locknuts yet.
Repeat this step with the Right Rear Upright (not
shown).
8.
Press two 48mm Round Inner Caps (23) into the
ends of the two Carriage Tubes (11). Screw the
Carriage Tubes onto the Weight Carriage (10) as
shown. Make sure the Carriage Tubes are fully
tightened.
7
8
34
15
6
15
4
23
23
11
11
10
32
9.
Route the Cable (31) up through the Lat Tower
(8) and over an 89mm Pulley (26). Attach the
Pulley inside of the Lat Tower with an M10 x
75mm Bolt (40), two M10 Washers (33), two
Spacers (28), and an M10 Nylon Locknut (32).
Make sure the large ball on the Cable is in the
indicated position.
10. Wrap the Cable (31) over an 89mm Pulley (26).
Attach the Pulley and a Cable Trap (27) to the
bracket on the Lat Tower (8) with an M10 x 75mm
Bolt (40). Do not thread a Locknut onto the
Bolt yet. Make sure the Cable Trap is inside of
the bracket and oriented to hold the Cable in
the groove of the Pulley.
9
10
Large
Ball
31
40
8
32
28
33
26
33
28
31
26
27
40
8