NordicTrack NTSY59210 - Manual (Page 12)

12
20. Wrap the Press Cable (101) around a 115mm
Pulley (54). Attach the Pulley and a Cable Trap
(52) to the top set of holes in a pair of Pulley
Plates (35) with an M10 x 50mm Bolt (77) and an
M10 Nylon Locknut (93). Be sure the Cable Trap
is turned to hold the Cable in the groove of
the Pulley.
21. Route the Press Cable (101) over a 115mm
Pulley (54) and through the Press Upright (16).
Attach the Pulley inside the Press Upright with an
M10 x 65mm Bolt (88), two M10 Washers (89),
two 15mm x 12mm Spacers (62), and an M10
Nylon Locknut (93).
19.
Locate the Press Cable (101). Route the eyelet
end of the Cable through the indicated hole in the
Press Upright (16).
Wrap the Press Cable (101) around a 115mm
Pulley (54). Attach the Pulley inside the Press
Upright (16) with an M10 x 65mm Bolt (88), two
M10 Washers (89), two 15mm x 12mm Spacers
(62), and an M10 Nylon Locknut (93).
19
20
21
Cable Assembly
IMPORTANT: Refer to the Cable Identification
Chart on page 26 for help identifying the
cables. Do not overtighten the bolts and
nuts attaching the pulleys; the pulleys must
be able to turn freely.
22. Wrap the Press Cable (101) around a 115mm
Pulley (54). Attach the Pulley to the bracket on
the Press Frame (12) with an M10 x 70mm Bolt
(79). Make sure the Bolt is inserted from the
indicated side. Do not thread a locknut onto
the Bolt yet.
22
62
54
101
93
16
89
89
88
62
54
35
35
77
93
52
101
62
88
89
89
54
62
93
16
54
101
Bracket
12
79
101