NordicTrack NTSY59210 - Manual (Page 20)

20
50. Press four 19mm Round Inner Caps (70) into the
ends of the two Short Pad Tubes (38).
Slide a Short Pad Tube (38) through the hole in
the Leg Lever (4). Slide two Foam Pads (43) onto
the ends of the Pad Tube.
Slide a Short Pad Tube (38) through the hole in
the Seat Frame (3). Slide two Foam Pads (43)
onto the ends of the Pad Tube.
52. Screw the Seat Knob (98) into the Seat Frame
(3).
Pull the Seat Knob (98) out as far as it will go.
Slide the Seat Bracket (5) into the Seat Frame (3)
and engage the Knob into an adjustment hole in
the Seat Bracket. Tighten the Knob.
53. Press two 25mm x 50mm Inner Caps (69) into
the Backrest Frame (14). Attach a 38mm Bumper
(48) and the 25mm Bumper (60) to the Backrest
Frame with two M4 x 20mm Self-tapping Screws
(65) and two M4 Washers (24).
Slide the adjustment arm on the Backrest Frame
(14) through the bracket on the Press Upright
(16). Tighten the Pin w/Knob (58) into the Press
Upright and engage the adjustment arm.
Attach the Backrest Frame (14) to the Press
Upright (16) with an M10 x 80mm Bolt (92) and
an M10 Nylon Locknut (93).
51. Attach the Seat (49) to the Seat Bracket (5) with
four M6 x 16mm Screws (85). Note: The Seat
Bracket will be closer to the rear edge of the
Seat.
52
53
51
50
43
70
38
4
3
70
43
43
49
5
85
Rear
Edge
85
98
3
69
69 93
48
60
24
65
92
58
14
14
16
65
24
5