NordicTrack NTSY59210 - Manual (Page 17)

17
39. Wrap the Butterfly Cable (102) around a 115mm
Pulley (54). Attach the Pulley and a Cable Trap
(52) to the bracket on the Press Base (1) with an
M10 x 45mm Bolt (86) and an M10 Nylon Locknut
(93). Be sure the Cable Trap is turned to hold
the Cable in the groove of the Pulley.
41. Locate the Rear Cable (103). Wrap the Cable
under a 115mm Pulley (54). Attach the Pulley to
the indicated bracket on the Rear Base (2) with
an M10 x 45mm Bolt (86) and an M10 Nylon
Locknut (93).
42. Wrap the Rear Cable (103) around a 115mm
Pulley (54). Attach the Pulley to the indicated
bracket on the Press Base (1) with an M10 x
45mm Bolt (86) and an M10 Nylon Locknut (93).
40. Attach the end of the Butterfly Cable (102) to the
Right Butterfly Arm (7) with an M10 x 40mm Bolt
(83), a 15mm x 12mm Spacer (62), an M10
Washer (89), and an M10 Nylon Locknut (93).
Make sure the Spacer is inside the loop in the
Cable.
39
40
41
42
86
54
102
93
1
52
102 93
7
62
89
83
93 2
54
86
103
93
103
54
86
1