NordicTrack NTSY59210 - Manual (Page 19)

19
48. Attach the Shroud (18) to the two M8 x 90mm
Bolts (90) in the Rear Top Frame (19) with two
M8 Nylon Locknuts (75).
Tighten the two M8 x 90mm Bolts (90) in the Rear
Base (2) into the Shroud (18).
49. Press two 25mm Round Inner Cap (55) into the
ends of the Long Pad Tube (37).
Center the Long Pad Tube (37) in the tube on the
Press Upright (16). Tighten the M6 x 20mm Self-
tapping Screw (63) into the Pad Tube.
Slide two Foam Pads w/Large Holes (108) onto
the ends of the Long Pad Tube (37).
48
49
90
108
108
55
55
63
Tube
16
37
75
90
19
2
18
Seat Assembly
47. Slide the tether on the Weight Pin (30) onto the
tube on the Top Weight (32). Rest the M12
Washer (76) on the tube.
Thread the M12 Nut (96) onto the bolt on the end
of the Rear Cable (103). Thread the bolt into the
tube in the Top Weight (32) until there is no slack
in the Cable.
Tighten the M12 Nut (96) against the M12
Washer (76).
Note: If you have purchased the hack squat
extension (model NTSY3921), complete steps
9–16 in the NTSY3921 manual.
47
103
30
32
Tube
96
76