NordicTrack NTSY59210 - Manual (Page 16)

16
36. Locate the Butterfly Cable (102). Attach one
end of the Cable to the Left Butterfly Arm (6) with
an M10 x 40mm Bolt (83), a 15mm x 12mm
Spacer (62), an M10 Washer (89), and an M10
Nylon Locknut (93). Make sure the Spacer is
inside the loop in the Cable.
37. Wrap the Butterfly Cable (102) around a 115mm
Pulley (54). Attach the Pulley and a Cable Trap
(52) to the indicated bracket on the Press Base
(1) with an M10 x 45mm Bolt (86) and an M10
Nylon Locknut (93). Be sure the Cable Trap is
turned to hold the Cable in the groove of the
Pulley.
38. Wrap the Butterfly Cable (102) around a 115mm
Pulley (54). Attach the Pulley to the bottom of the
Double “U”-bracket (36) with an M10 x 45mm Bolt
(86) and an M10 Nylon Locknut (93).
35. Insert a 115mm Pulley (54) into the Leg Lever (4).
Route the High Cable (100) under the Pulley.
Attach the Pulley inside the Leg Lever with an
M10 x 65mm Bolt (88), two M10 Washers (89),
two 15mm x 12mm Spacers (62), and an M10
Nylon Locknut (93).
Slide a Cable Ball (78) onto the end of the High
Cable (100). Thread the M10 Nut (25) all the way
onto the Cable Eye (22). Tighten the Cable Eye
into the end of the Cable. Tighten the M10 Nut
against the Cable Ball.
Press a 50mm Square Inner Cap (72) into the
bottom of the Leg Lever (4).
35
36
37
38
88
89
89
62
72
54
62
4
93
100
78
25
22
62
93
89
102 83
102
93 54
52
86
1
93
36
54
86
102
6