Netac Tech T600 - Manual (Page 12)

Netac AirTrack T600 Mini Wireless Router
7
Access Point: Child = Repeater-2
Repeater-2: Parent = Access Point; Child = Repeater-3
Repeater-3: Parent = Repeater-2; No Child
Figure 3.3 Repeater Mode (Parent/Child MAC Addresses)
3.3 Point-to-Point (P2P) Mode
Two T600 devices, each in Point-to-Point (P2P) Mode, establish a wireless connection between two wired
networks, as shown in Figure 3.4. The two T600 devices operating in P2P Mode do not allow client
connecting to it directly.
Figure 3.4 P2P Mode (Wireless Bridge)
To configure T600 devices to establish a P2P wireless bridge, ensure the following:
1. Enter the MAC address of T600 P2P-2 device in the P2P MAC address field in T600 P2P-1 device (on
the P2P Mode Setup page, Figure 5.8).
2. Enter the MAC address of T600 P2P-1 device in the P2P MAC address field in T600 P2P-2 device (on
the P2P Mode Setup page, Figure 5.8).
Section 5.3 "P2P Mode Setup Page" describes the configuration details for this mode.