Netac Tech T600 - Manual (Page 20)

Netac AirTrack T600 Mini Wireless Router
15
Table 5.4 AP Router Mode - Advanced Settings
Field Description
Beacon Interval Beacon interval (milliseconds).
RTS Threshold RTS threshold.
DTIM Interval DTIM interval.
Protection Mode Allows user to force 802.11g Protection (RTS/CTS) mode off.
Transmit Rate Select transmit rate: Auto (Default) or a fixed rate.
Preamble Type Select: Short preamble, Long preamble or Auto.
Connect Repeater Disable/Enable the use of a Repeater.
Repeater MAC Address MAC address for each Repeater. Up to two Repeaters can be connected.
5.1.2.1 Connect Repeater
Up to two Repeaters can be connected. If a Repeater is used along with the Access Point, the settings steps
are the following:
1. Go to the Advanced Settings Page.
2. Select Enable for the Connect Repeater field.
3. Enter the MAC address for each Repeater in the Repeater MAC Address field.
5.1.3 AP Router Mode - Access Filter (MAC Filter List) Setup
Click the Access Filter: Setup button in the AP Router Mode setup page (Figure 5.2) to access the Access
Filter page. The Access Filter page allows the user to configure T600 to allow or deny association to itself
based on the MAC address of the client. Up to 32 MAC addresses can be added to the list. Figure 5.6 and
Table 5.5 detail the options.