National Instruments FIELDPOINT FP-1600 - Manual (Page 6)

FP-1600 6 www.natinst.com
Figure 6 shows the connector pinouts for FieldPoint Ethernet
cables.
Figure 6. Ethernet Cable
Powering the FP-1600
Caution Connect the FP-1600 to the terminal base before
applying power to the FP-1600 to avoid damaging the
FP-1600 or a terminal base.
Each FP-1600 on your network requires an 11–30 VDC power
supply. The FP-1600 filters and regulates this supplied power and
provides power for all the I/O modules in the bank. Therefore, you
do not need to provide power separately to each FieldPoint I/O
module in the bank. If your field I/O devices need to be powered
separately, you can use the terminals provided on each terminal
base for such power supply connections.
The power connector is a 6-pin screw terminal connector whose
pinout is shown in Figure 7.
Connector 1 Connector 2
pin 1 pin 1 pin 8 pin 8