Step 2 - installing your modem driver, Windows xp – NetComm IN5699 User Manual

Page 4

Advertising
background image

www.netcomm.com.au

Rev.2 - YML609

Page 4

InModem56 V.92

3. Push the Modem card down firmly so

it is seated all the way to the bottom
of the PCI slot.

4. Plug one end of the RJ-11 telephone

cable (supplied with the modem) into
the line in the jack socket on the back
plate of the modem. Plug the other
end of the cable into the Wall jack
socket. If you wish to run a normal
telephone from the same line, plug
your telephone into the Telecom
Extension Socket.

5. Reassemble your computer case.

Connect the power cable and start
your computer. The hardware
installation is complete.

Step 2 - Installing your Modem Driver

Start your computer and, once fully booted, insert the NetComm Driver CD into your
CD-ROM drive
. Refer to the appropriate section relating to your operating system to
continue.

Windows XP

The Windows XP operating system will
automatically install a generic modem
driver after you turn on your computer.
You will then need to install the correct
NetComm modem driver from the
NetComm Driver CD.

1. Go to the “Start” button in the right-

bottom corner of the screen. Select
“All Programs” and then “Run”.

2. Type in the location of the driver

“D:\Drivers\IN5699_4\setup.exe” file
on the Driver CD in the CD-ROM
drive where D:\ is the letter of your
CD-ROM drive. Click “OK”.

Advertising