RCA Scenium L50000 - Manual (Page 53)

Chapter 3 The Remote Control Chapter 3 The Remote Control
49
3. Press and hold (the backlight button) until CODE SET appears in the
remote’s display window. Press the OK button.
4. Press the down arrow button to scroll to the desired component (TV, VCR,
TAPE, LDP, DAT, DVD, CD, TUNER, AMP, HOME, MISC, PHONO, CAB, SAT
VIDEO). In this example, press the down arrow button until VCR appears in
the remote control’s display.
5. Use the number buttons on the remote to enter the code for your brand (the
Code List starts on page 62). Press OK.
SUCCESS appears in the remote control’s display window when the code is
correct.
If NOT FOUND appears in the remote control’s display window, repeat step 5
by entering the next code from the list.
6. To exit, press the CLEAR button (EXIT SETUP appears and the remote is ready
to use).
7. Make sure the remote has correctly programmed the desired component (in
this example, your VCR): press the VCR button followed by the ON•OFF to
see if your VCR turns on. If the component doesn’t turn on, try the following:
• Try again by repeating the previous steps listed. Make sure you’re looking
in the correct section of the code list (i.e., you might have the correct
brand name, but you might be looking at the wrong type of component).
• Try programming the remote using one of the automatic code search
methods (go to page X).
• Use the Learning Feature to transfer the component’s most important
functions to your LCOS TV remote control (go to page 45 or 47).
• Review the following notes.
Notes:
DIRECTV
VCR 1 VCR 2
ON•OFF TV
DVD
AUX AUD
M1
L1
M2
L2
M3
L3
FRONT
SKIP MUTE
CH +
VOL + VOL -
CH - CENTER REAR
GO BACK FORMAT
TEST
GUIDE INFO
AM•FM
OK LEVEL + LEVEL -
MENU
PROGRAM
CLEAR
1 2 3
4 5 6
7 8 9
0 INPUT ANT
FUNCTION
STOP PAUSE REC
PLAY FWD REV
SWAP CH CTRL PIP WHO
DSP ON•OFF DSP MODE
DELAY
Display
window
Component
buttons and
ON•OFF button
The down
arrow button
The OK
button
The backlight
button
The up arrow
button
• This remote control cannot be programmed to operate some brands of components.
• If approximately 30 seconds passes before a button is pressed, the display window stops transmission to
conserve battery life. If this occurs, restart from step 1.
• To exit programming mode, press the CLEAR button at any time (EXIT SETUP appears in the remote’s
display to confirm that no new codes have been entered).