RCA Scenium L50000 - Manual (Page 62)

Chapter 3 The Remote Control Chapter 3 The Remote Control
58
How to Reset the Remote
Operations Reset
Operations reset clears all programming from the remote control EXCEPT the
buttons you’ve programmed to operate other components.
1. Press and hold (the backlight button) until CODE SET appears in the
remote’s display.
2. Step through the programming menu by pressing the down arrow button until
OPS REST appears in the remote’s display, then press the OK button.
3. Once you press the OK button, CLR SETUP appears until the OK button is
pressed again.
4. After the OK button has been pressed, the remote will perform a complete
Operations Reset. Once the Operations Reset is complete the remote will exit
the Operations Reset mode and return to its normal operation.
Note: Press the CLEAR button at any time to exit. EXIT SETUP will appear and
the remote will return to its normal operation.
Manufacturing Reset
The Manufacturing Reset returns your remote to the way it was when it was packed
with product at the manufacturing facility. All programming will be cleared.
1. Press and hold (the backlight button) until CODE SET appears in the
remote’s display.
2. Immediately press and release the RECORD button. The remote automatically
enters the programming mode where the Manufacturing Reset will be accessed.
3. Step through the programming menu by pressing the down arrow button until
MFR RESET appears in the remote’s display, then press the OK button.
DIRECTV
VCR
1
VCR
2
ON•OFF TV
DVD
AUX AUD
M1
L1
M2
L2
M3
L3
FRONT
SKIP MUTE
CH +
VOL + VOL -
CH - CENTER REAR
GO
BACK FORMAT
TEST
GUIDE INFO
AM•FM
OK LEVEL + LEVEL -
MENU
PROGRAM
CLEAR
1 2 3
4 5 6
7 8 9
0 INPUT ANT
FUNCTION
STOP PAUSE REC
PLAY FWD REV
SWAP CH
CTRL PIP WHO
DSP
ON•OFF
DSP
MODE
DELAY