RCA Scenium L50000 - Manual (Page 60)

Chapter 3 The Remote Control Chapter 3 The Remote Control
56
Discrete Clear
Use the following steps to delete a discrete code that you added.
1. Press and hold (the backlight button) until CODE SET appears in the
remote’s display.
2. Step through the programming menu by pressing the down arrow button until
DISCRETE CLEAR appears in the remote’s display, then press the OK button.
3. Press mode button (also known as a component button) of the discrete code
that you want to clear.
4. Press the button assigned to the discrete code you want to delete ( DELETED
appears).
5. To exit, press and hold the CLEAR button until EXIT SETUP appears in the
display.
How to Use the Mode Mapping Feature
The Mode Mapping feature allows you to custom map one component to another
component button. Mode Mapping is another way to program the remote control to
operate another component.
1. Press and hold (the backlight button) until CODE SET appears in the
remote’s display.
2. Step through the programming menu by pressing the down arrow button until
MODE MAP appears in the remote’s display, then press the OK button.
3. FROM MODE appears in the remote’s display prompting you to select a
component button.
4. Press the component button of your choice to apply the component to be
selected as desired.
DIRECTV
VCR
1
VCR
2
ON•OFF TV
DVD
AUX
AUD
M1
L1
M2
L2
M3
L3
FRONT
SKIP MUTE
CH +
VOL + VOL -
CH - CENTER REAR
GO
BACK FORMAT
TEST
GUIDE INFO
AM•FM
OK LEVEL + LEVEL -
MENU
PROGRAM
CLEAR
1 2 3
4 5 6
7 8 9
0 INPUT ANT
FUNCTION
STOP PAUSE REC
PLAY FWD REV
SWAP CH
CTRL PIP WHO
DSP
ON•OFF
DSP
MODE
DELAY