RCA Scenium L50000 - Manual (Page 63)

Chapter 3 The Remote Control Chapter 3 The Remote Control
59
4. Once you press the OK button, CONFIRM appears in the remote’s display
window. Press OK.
5. After you press the OK button (the remote is returned to factory settings).
Note:
Press the CLEAR button at any time to exit the programming mode. An EXIT
SETUP message will appear and the remote will return to its normal
operation.
How to Operate Audio Functions
The operation of your audio product may vary. These instructions are provided for
example only. Please consult the manual that was packed with your audio product.
How to turn on the receiver or minisystem
Point the remote control at the receiver and press the AUD button. The receiver
should turn on. In some cases, it may require pressing the AUD button and then the
ON•OFF button to turn on the system.
Selecting the receiver’s components
For most RCA audio/video receivers, the component input is selected by pressing
the corresponding component button. When the AUD button is programmed to
non-RCA receivers, the number buttons might select the component input (1 = CD;
2 = Tape; 3 = Tuner; 4 = TV; 5 = VID1; 6 = VID2).
Operating A CD Player Or Tape Deck
Use the PLAY, REV, FWD, REC, STOP & PAUSE buttons for CD player and tape
decks. In some cases, the Preset buttons (CH + and CH -) might work in changing
tracks on your CD player. It might be necessary to program a component button to
your CD or tape player.
DIRECTV
VCR
1 VCR 2
ON•OFF TV
DVD
AUX AUD
M1
L1
M2
L2
M3
L3
FRONT
SKIP MUTE
CH +
VOL + VOL -
CH - CENTER REAR
GO BACK FORMAT
TEST
GUIDE INFO
AM•FM
OK LEVEL + LEVEL -
MENU
PROGRAM
CLEAR
1 2 3
4 5 6
7 8 9
0 INPUT ANT
FUNCTION
STOP PAUSE REC
PLAY FWD REV
SWAP CH CTRL PIP WHO
DSP ON•OFF DSP MODE
DELAY
Display
window
The backlight
button
AUD (audio)
button
PLAY, REV, REC,
STOP, PAUSE
buttons