Roland V-Synth GT - Manual (Page 123)

123
Editing a Tone (Pro Edit)
Com MOD COSM1/2 TVA OSC1/2 AP Syn Effects
How to Apply the LFO
● Apply the LFO gradually after the key is pressed
fig.LFO-1.e
● Apply the LFO immediately when the key is
pressed, and then gradually begin to decrease
the effect
fig.LFO-2.e
● Apply the LFO gradually after the key is
released
fig.LFO-3.e
● Apply the LFO from when the key is pressed
until it is released, and gradually begin to
decrease the effect when the key is released
fig.LFO-4.e
Delay Time The time from when the keyboard is
played until the LFO begins to be ap-
plied.
Fade Mode ON <<
Fade Time The time over which the LFO amplitude
will reach the maximum after the Delay
Time has elapsed.
Delay Time The time that the LFO will continue after
the keyboard is played.
Fade Mode ON >>
Fade Time The time over which the LFO amplitude
will reach the minimum after the Delay
Time has elapsed.
Note on
high (more)
low (less)
Pitch
Cutoff Frequency
Level
Pan
Delay
Time Fade Time
Depth
Note
on
high (more)
low (less)
Delay Time Fade Time
Depth
Pitch
Cutoff Frequency
Level
Pan
Delay Time The time from when the keyboard is re-
leased until the LFO begins to be applied.
Fade Mode OFF <<
Fade Time The time over which the LFO amplitude
will reach the maximum after the Delay
Time has elapsed.
Delay Time The time that the LFO will continue after
the keyboard is released.
Fade Mode OFF >>
Fade Time The time over which the LFO amplitude
will reach the minimum after the Delay
Time has elapsed.
high (more)
low (less)
Delay
Time Fade Time
Depth
Note
off
Note
on
Pitch
Cutoff Frequency
Level
Pan
Note
on
high (more)
low (less)
Delay
Time Fade Time
Depth
Note
off
Pitch
Cutoff Frequency
Level
Pan
V-Synth-GT_e.book 123 ページ ２００７年４月９日 月曜日 午後１時４６分