Roland V-Synth GT - Manual (Page 192)

192
Sample Mode
1. Access the Sample Top screen (p. 165).
2. Touch <Info>.
The Sample Information screen appears.
fig.04-10a_50
In the Sample Information screen you can check the following information for the sample.
• Encode type (p. 188)
• Sampling type (p. 174)
• Loop point location (Loop Start, Loop End) (p. 185)
• Time signature (p. 186)
• Original tempo (p. 186)
• Original pitch
• Original fine tune
Original Tempo, Original Pitch, and Original Fine Tune can be modified in this screen.
If you want to set an accurate original tempo, make settings in the sample editing screen (p. 186).
3. When you have finished viewing the information, touch <OK> to close the window.
Checking Sample Information
Parameter Value Description
Original Pitch C-1 (0)–
G9 (127) Specifies the key that will play the sample at the pitch at which it was sam-
pled.
Original Fine Tune -50– +50 Adjusts the current pitch in one-cent steps (1/100 of a semitone) over a
range of 1/2 semitone upward or downward.
LOOP MODE One Shot The sample will not loop, regardless of the Loop Switch (p. 99) setting of the
patch.
One Way If the Loop Switch (p. 99) of the patch is on, the sample will loop in the for-
ward direction between “LOOP START” and “LOOP END.”
Alternate If the Loop Switch (p. 99) of the patch is on, the sample will loop alternately
backward and forward between the “LOOP START” and “LOOP END.”
V-Synth-GT_e.book 192 ページ ２００７年４月９日 月曜日 午後１時４６分